| |
Sizing
Correct sizing of air conditioners is very important -
too big is just as bad a too small. Use size chart for
estimation or refer to Access air for the correct
selection of air conditioning system.
Installation
Indoor units are to be mounted on an external wall.
Outdoor units must be located outside for hot air to
discharge. The condenser can not be boxed in as
ventilation to unit is necessary.
Electricity
All split air conditioning systems up to 10.5 kW require
240 volt, single phase power. Units 5.2 kW and above
require a separate circuit from the electrical board,
still only 240V single phase.
Running Costs
Estimated average running cost of a split air
conditioning unit, are as follows:-
Small unit 10 cents per hour
Medium unit 20 cents per hour
Large unit 35 cents per hour
Multi split air conditioning systems
These refer to one outdoor unit (condenser) with two or
more indoor units (fancoil). These are designed for high
density buildings i.e. townhouses and apartments with
limited outdoor area. One indoor to one outdoor air
conditioning unit is usually more suitable for most
applications.
Inverter
Inverter stands for closer control on temperature and
has a saving on the running costs of the unit. This is
achieved by a variable speed compressor.
Remote control
All units have a remote control with a timer, sleep
modes and humidity control. These are battery operated.
Filters
All units have filters supplied in the indoor unit.
Check brochures as to whether the manufacturer supplies
additional filters.
Water
The indoor unit absorbs moisture out of the atmosphere
on the cooling mode and the outdoor unit drains water on
the heating mode. During installation a drain is run
from the indoor unit through the outdoor unit and into
the nearest down pipe, drain or garden bed.
Warranty
All split air conditioning systems sold have a five year
manufacturer’s warranty if installed to specifications
by licensed refrigeration technicians. Once unit is
installed an annual maintenance program is available and
recommended by the manufacturer to ensure unit works to
its full capacity for the life of the system.
A.B.N. 56
086 059 725 • Lic. No. 116071C
• P.O. Box 163 • Narrabeen • NSW 2101 • Phone 0416 139
115 • Fax 02 9979 2134
|
 |
 |
